BASIC COMPONENTS:

BASIC AIRSOFT TYPES:


SPRING GUNS:

1. Mostly made out of Plastic. Some higher grade Spring Sniper Rifles are made of metal.
2. Single Cocking, or Bolt Action. You need to manually cock the gun for every trigger pull (shot).
3. Most econimical because they are inexpensive to produce and don't require any additional power source.




GAS GUNS:

1. Come in Plastic and Metal Body varieties.
2. Uses either Green Gas (or Propane with a Propane Adapter), 134A Gas or CO2 as it's power source. Some
Green Gas guns are CO2 Compatible and can use both types of gas. See gun descriptions for these models.
3. All are Semi-Auto (one shot per Trigger pull) with select models being Full-Auto (continuous fire).
4. Comes either "Non-Blowback" (no slide movement), or with "Blowback" (slide moves back with every shot to
simulate recoil) action.

How to Load Gas (Green Gas or 134A - Instructions may vary):

1. Gun should be set to "Safe". Remove magazine from the pistol by pressing the mag release button.

2. Fill the magazine with gas by inserting gas canister into inlet at the bottom of the mag. Make sure the gas canister is perfectly lined up, vertically with the magazine. Press firmly down onto canister to fill. Amount depends on capacity of the mag, but generally fill time is 2 - 5 seconds.

How to Load Gas (Co2 - Instructions may vary):

1. Remove mag (same as Green Gas Guns). On some models, slide open the grip compartment. 2. Turn the knob at the bottom of the mag, clockwise to fully open. 3. Insert Co2 cartridge.

4. Turn knob counter-clockwise fully, to pierce Co2 cartridge. Reinsert mag (or close grip compartment) into the gun until "click" locked into place.

How to Prepare for Fire:

1. Load the BB's. Pull down the magazine follower and insert BB's. Do not overload (consult your gun manual). Reinsert mag into your gun until it is "click" locked in place.

2. To load the first round into the chamber, pull the slide all the way back, then release back forward (On most blowback models). The hammer should lock back. Take gun off "Safety". Gun is now ready for fire.

Additional Gas Tech Tips:

1. Magazines may be extremely cold right after fill up. Pleae allow the mag to warm 5 minutes before using, to
receive full power from the gas.
2. Rapid firing may cause the mag to freeze up, causing decrease in power due to the gas not expanding correctly.
If this happens, warm the mag with your hands or allow to warm, before proceeding. Gas gun are most efficient and
best performing, when used in warm weathers.
3. Always release any excess gas before storing away, to avoid damage to the mag seals. The best way to do this
is fire the gun until out. There is a gas release button on most mags, but releasing the gas constantly through this
method may prematurely wear out and damage the Seals and O-Rings.
4. Be sure to spray silicone oil into the top nozzle of the magazine, every 5-6 mag uses. This is done by pressing
the release valve and putting a quick spray of silicone oil into the exhaust valve. This will lube the Seals and O-Rings.




ELECTRIC (AEG) GUNS:

1. Come in Plastic and Metal Body varieties.
2. Uses rechargeable batteries as a power source.
3. Most all are both Semi-Auto (one shot per Trigger pull) and Full-Auto (continuous fire).
4. Some are starting to come with "Blowback" (slide moves back with every shot to simulate recoil) action.

Common Types of Gearboxes & Motors:

VER. 2: Used in most M4/ M16/MP5 Style AEG's

VER. 3: Used in most SIG, AK & G36 AEG's

• SHORT • MEDIUM • LONG

How to Charge the Battery:

1. Charge the battery according to your manual. 2. Connect charged battery with the AEG's connector. 3. Replace battery into the battery compartment of your AEG.

Estimated Battery Charging Times: Based on milliamp of the battery divided by the charge/output rate of the charger. For example, a 9.6v 1200 battery using an 500mA Charger, the full charge time would be 2.4 hours. (1200 divided by 500).

How to Prepare the Magazine (Hi-Cap - Different models, Instructions may vary)):

1. Press the Mag Release Button and remove Mag from Gun. 2. Open Trap Door on Mag and insert BB's (a large amount is needed on Hi-Caps).

3. Wind the wheel at the bottom of the mag until the BB's are fed up the feeding tube. It may take numerous turns, until added pressure is felt on the wheel, or when it "double-clicks". 4. Replace the mag into the gun until it "Clicks" and is locked into place. 5. It is ready for fire. On Hi-Caps, you must keep winding the wheel for a constant feed of BB's.

Additional AEG Tech Tips:

1. Leaving a battery charging overnight with a standard wall charger may overheat the batteries cells and cause
damage to both the battery and charger.
2. Do not hold down and fire on Full Auto for long periods as this may cause excessive wear, or damage, to your
gearbox components and motor. It is better to fire in controlled bursts in Full Auto mode.
3. Some batteries have an exact fit into their battery compartments and require exact placement of battery and
wires, to fit.
4. Raising battery voltage increases the "wear and tear" of an AEG's internals. Also, it may increase an AEG's
"Rate of Fire", but not it's FPS velocity (Feet Per Second).
5. The primary way to increase FPS is to upgrade the spring. But, please note, that this will add stress to other
gearbox components not upgraded. It is recommended to upgrade other internal gearbox parts that are affected
by an upgraded spring.
6. Higher Milliamp (mah) batteries have higher energy storage that translate into longer AEG playing times.
7. Adjust the Hop Up to achieve a straighter trajectory on your BB, but do not add too much Hop Up, which may
cause BB jams.
8. If your AEG stops working, 1st things to check is if the battery wire connections and if the battery is sufficiently
charged. Next, check that the fuse is not blown. Check that the "Safety" is off. If it still does not work, consult
your warranty or manual.
9. If it makes noise, but does not fire, check that the Hi-Cap Mag is sufficiently filled and wound. Next, check for
BB jams. Also check the motor height adjustment at the bottom of the grip. If it still does not work, consult your
warranty or manual.
10. Perform regular maintenance on your AEG to achieve it's best, longest lasting performance.


BB'S 101 (IMPORTANT INFO):



1. Do not use cheap, inexpensive BB's. The costs are slightly less than precision BB's, but cheap BB's
are irregular in shape, made of cheap materials, produced to a lower standard of manufacturing and
will cause major damage to your prized airsoft guns! Cheap BB's will break and jam your airsoft guns,
causing damage to the cylinder, piston and gears!
2. Using cheap BB's will void the warranty on any airsoft gun we sell.
3. On the other hand - Precision BB's are perfect spheres, without imperfections. They normally are
polished for the smoothest possible surface. This produces less friction, a tighter fit in the barrel and
allows for better performance and FPS.
4. We only sell High Precision, quality BB's at Blazing Toys.
5. Spending less on cheap BB's, usually means spending more on repairs. Please only use High Grade
Precision BB's in your gun.

BASIC TYPES OF AIRSOFT PLAY:

1. CQB: Close Quarter's Battle, or Close Quarters Combat, a very exciting, quick, and effective way of playing
airsoft. Since CQB is usually played in relatively small areas, and indoors, you get to the heat of the battle very
quickly. It is necessary to be carrying a smaller gun in CQB, so you can maneuver in the small areas, and you
have to be able to move your gun where necessary very quickly. Generally, when we label an AEG as "CQB"
version, most likely it will have a shorter barrel and a retractable, or no stock.

If you're the kind of guy who enjoys SWAT type simulations, and/or special forces making raids, etc. CQB is for
you. There is a lot you can do with CQB, all kinds of realistic scenarios such as disarm the bomb, rescue the
hostages, etc. Room to room battles, battles between buildings, etc... are indicative of CQB play. Organized
CQB fields usually limit airsoft guns to 350 FPS and below.



2. Woodland or Field
Probably the most common airsoft arena is the outdoors, and the Woods or in "the Field". Very simple and
efficient, it requires no money in most cases, and no work to get it set up, you just go out there and you're
set. The Woodland / Field provides only natural cover, which makes it fun, and adds a lot of strategy, since it
is quite difficult to maneuver close to the enemy with out being seen, or heard. The Woods are also a favorite
destination by snipers.

Woodlands takes a lot more time for actual firing to start, but there is a lot more natural feel, and when the
battles do get started, they are a blast. It is a lot better to hear pellets ripping through leaves and brush, then
bouncing off a wall. You also can get dressed up in camouflage, and get your face painted, etc. The woods allow
for a lot more creativity and realism if you're going from a military standpoint. Not saying there isn't CQB in real
wars, but when it is played in airsoft it more simulates SWAT teams then the military. But there is good special
forces simulation in CQB. In the woods your using your surroundings, and trying to out smart the enemy, all
natural, and in some cases dozens of acres to spare. Organized fields usually limit airsoft guns to 400 FPS and
below.

BASIC SAFETY:



1. Treat your airsoft gun as if it is loaded at all times.
2. Keep a barrel plug on while not shooting.
3. Always be aware of what you’re aiming at. never point, or shot at People or Animals.
4. Keep your finger off the trigger until you’re ready to shoot.
5. Keep your gun on "Safe" mode, when not in use.
6. Never look down the barrel of a gun.
7. Be sure to clear the chamber after removing your magazine, to make sure there is not an extra round in your gun.

Public Places -
Since most airsoft guns are replicas of real firearms, you should never display, or brandish your airsoft
gun in public places. Treat your airsoft guns as if they were real guns. Exercise caution and safety at ALL TIMES!
Always transport your airsoft gun in gun carrying cases, or bags.

Protectice Gear -
The minimum safe level of gear required to participate in airsoft includes a pair of impact-rated goggles to protect
participants' eyes. Do not use traditional prescription glasses and sunglasses, or goggles that are not designed
specifically for use with airsoft or paintball guns. these may break or shatter upon being struck, causing damage
to the eye. Full-face masks (similar to, and often including paintball masks) cover the rest of the face, protecting
vulnerable parts such as teeth.